Things That You Need To Know About Plasma Cutting
When you are doing a plasma cutting, it must always be accompanied with necessary safety measures just to avoid the arising of accidents or any mishaps.
The plasma cutter has an electric circuit that is found between the so-called torch and the work object. When there is a motion that moves the work object, the electric circuit will most likely begin to move that said object as well. Avoid contact with the torch body or work object as it may affect not only the plasma cutting that is going on but also your life as well.
There are so many types of metals and other electrically conductive metals that are always subject to plasma cutting. In order to make sure that the steels, welding materials and electrically conducive metals are properly done, the plasma cutters should have an appropriate amount of voltage electrical arc and a compressed gas that will carry and get the job done. An absolute high voltage electric arc is needed amounting to 100-200 volts to operate the plasma cutters unlike the welding cutter that normally carries lesser amount that the plasma cutter.
Never get the work object from while you are still cutting the object because it might lead to danger. Put the work object on the cutting bench spiraled by a ground table when the cutting process for the same is not still done. Always put the ground clamp in its proper place and never let it removed while doing the plasma cutting operation. Just let the ground cable together with the work object rest for a while but never let them be removed while you are still doing the cutting process.
Get yourself back up when gloves and boots when you are doing the plasma cutting process as your clothes and body will be dry thereafter.
Remind yourself all the time that you are prohibited to sit, stand, lie or touch and surfaces that are wet just to avoid danger when using the plasma cutter system. Make sure that the ground cable works well and connected to the work object when you are undertaking a plasma cutting process. You must entirely replace your plasma cutting machine If you have found out that your clamp is no longer usable or functioning.
Using boots and gloves is necessary as one must also have proper eye protection if you are in the verge of plasma cutter operation. Learning that there are so-called arc rays producing dangerous ultraviolet and infrared waves that has the tendency to cause cataracts and skin problem when you don’t keep a proper eye protection. Some of the necessary clothes and garments to prepare are the gloves, welding safety shoes, welding helmets, flame-retardant clothes, and trousers.
Source: plasma cutter